🔹 How to Use

🔹 Step 1: Mark Your Cut Line, use a pencil and ruler or level to mark where you want to cut on the wallboard, MDF, or chipboard. Double-check your measurements before cutting.
🔹 Step 2: Start with a Pilot Hole (if needed), if cutting in the middle of a board, drill a small hole just inside the marked area. This gives you a starting point for the saw blade.
🔹 Step 3: Saw Along the Line, insert the tip of the saw into the pilot hole or edge of the board. Use steady, forward strokes and let the sharp, hardened blade do the work. Keep your hand on the cushioned grip for comfort and control.
🔹 Step 4: Finish and Smooth the Cut, once the cut is complete, gently smooth any rough edges with sandpaper or a sanding block for a clean finish.

We work hard to make sure Amtech tools are reliable as well as affordable. However, if you have a problem with any product, we want to get your job up and running again as quickly as possible.

All our hand tools are backed by a three year product replacement warranty and our power tools range are covered for up to two years.

So if something develops a fault within the specified warranty period, we’ll replace it, subject to proof of purchase.